Chapter 23.25. LOCAL AMENDMENTS TO THE UNIFORM PLUMBING CODE 2012 EDITION  


§ 23.25.100. Local amendments to the Uniform Plumbing Code 2012 Edition.
§ 23.25.102. Delete.
§ 23.25.204.0. Definitions. - B -
§ 23.25.210.0. Definitions. - H -
§ 23.25.312.12.3. Rodent proofing.
§ 23.25.314.0. Trenching, excavation, and backfill.
§ 23.25.318.2. Pressure tests (10 psi or less).
§ 23.25.320.0. Mezzanines and platforms.
§ 23.25.403.3.1. Non-water urinals.
§ 23.25.403.4. Metered faucets.
§ 23.25.409.6. Access to whirlpool bathtub pump.
§ 23.25.415.2. Where required.
§ 23.25.418.6. Unvented garage floor drains.
§ 23.25.422. Minimum number of required fixtures.
§ 23.25.423.0. Minimum hot water supply temperature.
§ 23.25.506.0. Air for combustion and ventilation.
§ 23.25.507.0. Other water heater installation requirements.
§ 23.25.507.2. Seismic strapping for small water heaters.
§ 23.25.507.4.1. Water heaters located in mobile homes.
§ 23.25.507.5. Relief valve discharge.
§ 23.25.507.13. Installation in residential garages.
§ 23.25.508.0. Appliances on roofs.
§ 23.25.509.0. Venting of appliances.
§ 23.25.510.0. Sizing of category I venting systems.
§ 23.25.603.0. Cross-connection control.
§ 23.25.603.4. General requirements.
§ 23.25.603.4.8. Area drain sizing for backflow assemblies.
§ 23.25.603.5.6.4. Lawn irrigation.
§ 23.25.603.5.8. Water cooled equipment.
§ 23.25.603.5.10. Steam or hot water boilers.
§ 23.25.603.5.22. Potable water supply to dental chairs.
§ 23.25.603.5.23. Hydronic heating/cooling.
§ 23.25.603.5.24. Steam systems.
§ 23.25.603.5.25. Cooling towers.
§ 23.25.603.5.26. Tall buildings over 30 feet in height.
§ 23.25.603.5.27. Commercial hose bibbs.
§ 23.25.604.1. Materials - water pipe and fittings.
§ 23.25.604.2. Materials - copper tube.
§ 23.25.604.9. Materials - plastic pipe materials.
§ 23.25.606.3. Shut off valves in multi-family dwelling units.
§ 23.25.608.0. Water pressure, pressure regulators and pressure relief valves.
§ 23.25.609.3. Under concrete slab.
§ 23.25.609.4. Testing.
§ 23.25.609.10.1. Mechanical devices.
§ 23.25.609.11. Water supply accessibility.
§ 23.25.610.8. Size of meter and building supply pipe using Table 6-6.
§ 23.25.613.0. Indoor water meter setter.
§ 23.25.704.3. Commercial Dishwashing Machines and Sinks.
§ 23.25.712.1. Media.
§ 23.25.719.0. Cleanouts.
§ 23.25.724.0. Building drain accessibility.
§ 23.25.801.3. Bar and fountain sink traps.
§ 23.25.815.0. Soda fountains, condensates, drip pans, ice machines, and other similar equipment.
§ 23.25.906.8. Roof penetrations.
§ 23.25.908.2. Bathroom wet venting.
§ 23.25. Table 1002.2. Horizontal lengths of trap arms.
§ 23.25.1014.1. Grease interceptors.
§ 23.25.1017.1. Interceptors required.
§ 23.25.1101.1. Where required.
§ 23.25.1101.3. Material uses.
§ 23.25.1101.5. Subsoil drains.
§ 23.25.1101.6. Building subdrains.
§ 23.25.1101.9. Filling stations and motor vehicle washing establishments.
§ 23.25.1101.11.1. Primary roof drainage.
§ 23.25.1101.11.2.2. Combined system.
§ 23.25.1108.0. Controlled-flow roof drainage.
§ 23.23.1109.2. Methods of testing storm drainage systems.
§ 23.25.1207.2. Temporary gas installations—Permit required.
§ 23.25.1207.3. Temporary gas installations—Permit not required.
§ 23.25.1208.5.8.1. Pipe joints.
§ 23.25.1208.5.8.2. Tubing joints.
§ 23.23.1208.5.8.4. Metallic piping joints and fittings.
§ 23.25.1210.1.1. Cover requirements.
§ 23.25.1210.1.5. Piping through foundation wall.
§ 23.25.1210.1.8. Ground penetrations.
§ 23.25.1210.1.9. Fuel gas piping connectors.
§ 23.25.1210.1.10. Frost heave protection for copper tubing.
§ 23.25.1210.4.1. Manufactured home connections.
§ 23.25.1210.5.2. Medium pressure gas.
§ 23.25.1210.18. Above-ground outdoor piping.
§ 23.25.1213.3. Test pressure.
§ 23.25.1301.1. Where required.
§ 23.25.1309.1.1. Veterinary clinics.
§ 23.25.1309.8. Vacuum systems for dental offices.